BROADCAST STANDARDS Digital terrestrial TV / Radio DVB-T, DVB-T2 (T2-base, T2-lite), ISDB-T/Tb (full seg / 1seg), ATSC 1.0, ATSC 3.0, DAB, DAB+ Digital cable DVB-C, DVB-C2, J.83 annex-B, 16/64/256-QAM Digital satellite DVB-S, DVB-S2 VCM/ACM/CCM, DVB-S2x, DSS, QPSK Analogue Analogue terrestrial (PAL, SECAM, NTSC), FM RDS

SPECTRUM ANALYZER MODE From 5 MHz to 6 GHz

IPTV MULTICAST/UNICAST OPERATING MODE More than 20 measurements (including Jitter, Packet rate, Histogram + jitter, Inter Packet Arrival Time). Multicast. T2MI&BTS reception.

SD/HD/3G-SDI OPERATING MODE 3 Gbps input/output. Eye statistical diagram, CRC error detection, 16 AES3 audio channel monitoring, 1080p 60 pattern chart.

STREAMING ANALYZER MODE SRT reception in caller, listener, and rendezvous modes. More than 12 metrics including RTT, latency, NACK packets, and received TS analysis. OTT measurements.

WIFI 802.11 ac/a/b/g/n ANALYZER OPERATING MODE Spectrum analyzer + WiFi dongle. RSSI, Access point occupancy, SNR, Noise

ASI-TS OPERATING MODE ASI-TS TS, T2MI and BTS support

4G/5G (optional) TELEPHONY OPERATING MODE Dual SIM. Uplink/Downlink bands indication over the spectrum. Measurements: RSSI, RSRP, RSRQ, SINR, SRXLEV.

INPUTS AND OUPUTS Universal RF input (N-type, female 50 Ω) ASI/SDI input and output (BNC female, 75 Ω 3 Gbps) SFP+ connector Analogue audio/video input (jack 3.5 mm) HDMI™ output (v1.4b up to 3840x2160 pixels @30 Hz) USB 2.0 master/device (Type C). Mass storage and remote control commands Ethernet (RJ45) for webControl and remote control commands Optical input (FC/APC, female) 1 PPS / 10 MHz reference input IPTV input (RJ45 Ethernet, 10/100/1000 Mbps) Stereo headphone audio output (jack 3.5 mm) USB 3.0 host (A-type, USB-CDC devices) CAM (DVB-CI compliant, module input Double SIM card slot (optional)

FUNCTIONS SMPTE ST2110 measurements (optional) SRT measurements 4K decoder Screenshots Service recording Task planner Signal monitoring Remote control (webControl) Video/Audio streaming TS recording TS analysis IPTV multicast: measurement, decoding Eye diagram (HD-SDI, 3G-SDI) 8 GB internal memory, expandable via USB OTT Constellation diagram LTE ingress test Dynamic echoes analysis StealthID (instant identification of tuning parameters) PLS (Physical Layer Scrambling) Ultra fast spectrum MAX and MIN hold FM RDS measurement and decoding Datalogger Beacon-Flyaways SNG and VSAT Wideband LNB WiFi LTE 1.8 GHz Field strength Merogram Spectrogram MER by carrier GPS (included) coverage analysis ALP recording Full band optical power measurement SCAN + TILT Shoulder attenuation Network delay DVB-2 MI analysis Carrier Frequency Drift Test

OPTIONS Optical fibre: Selective optical power meter + optical to RF converter Advanced measurements for FM radio Advanced measurements for DAB/DAB+ digital radio 4G/5G measurements Optical SDI and ASI output Optical SDI and ASI input ST2110 protocol support

Comparative table ATLAS and RANGER analyzers

More details on ATLAS NG

What is ATSC 3.0 and what are its innovations?

ATSC 3.0 technical overview

Key factors that make ATLAS NG broadcast analyzer a multidisciplinary equipment

Quick reference guide (English) (2,38 MB)

Quick reference guide (Spanish) (2,38 MB)

User manual (English) (18,67 MB)

Quick reference guide (French) (3,77 MB)

User manual (Spanish) (18,71 MB)

Quick reference guide (German) (2,37 MB)

Firmware release 3.3.1 for ATLAS NG and ATLAS IP Update procedure: Requires ATLAS software version above 1.4.0. Reboot your equipment (important), then supply it by AC power to avoid running out of battery. Unzip the file to the root of a pendrive and insert it in the top USB port of the instrument. Perform the update by selecting Settings › Update. (652,96 MB)